Skip to main content

Piping Design and Inspectiton Guidance Summary


Comments

Post a Comment

Popular posts from this blog

MILL TEST CERTIFICATE is...?

  A Mill Test Certificate (MTC), or Mill Test Report (MTR), is issued by a manufacturer to certify the chemical and mechanical features of a product and its compliance to the applicable norms and technical specifications. Typically, Mill Test Certificates conform to the EN 10204 standard and are related to steel products. MILL TEST CERTIFICATE A mill test certificate to EN 10204 shows, generally, the following information: Type of certificate and standard (example EN 10204 3.1 or EN 10204 3.2) Manufacturer name Product name and dimensions Quantity covered by the certificate (example: tons, with heat numbers) Heat numbers and batch number (physically shown on the product as well) Final test result Dimensional measurements, to check compliance with allowed tolerances (example, for steel pipes: diameter, wall thickness, length, straightness) Material grade and applicable specification, including results of chemical and mechanical tests Results of additional tests, like hydrostatic, ul...
Post a Comment
Read more

Storage tank API 650 - NDE Requirements Summary

Post a Comment
Read more

Variable on Welding procedure specification (WPS) Refer to ASME sec IX

  Welding procedure specification (WPS) ASME sec IX A welding procedure specification is a written document providing direction to the welder (or welding  operator ). It contains all the necessary parameters viz. joints, base metals, filler metals, positions, preheat, PWHT, gas etc. (including ranges, if any) under which the welding process must be performed. These parameters are known as variables (as per ASME Section IX). Three types of variables are mentioned in the code, these are; Essential Variable Non essential Variable Supplementary Essential variable Essential Variables  (For WPS – QG-105.1 & QW-251.2):  A change in essential variable is considered to affect the mechanical properties (other than toughness) of the welded joint. Hence the WPS must be requalified, if the essential variable is changed. Note: QG-105.2 is for Welder. Supplementary Essential Variables  (QG-105.3 & QW-401.1):  A change in the supplementary essential variable will a...
Post a Comment
Read more